How do I reset my Buffalo AirStation nfiniti?

How do I reset my Buffalo AirStation nfiniti?

How to Hard Reset a Buffalo Router

1. Press and hold the reset button at the back of the Buffalo router for 30 seconds.
2. Disconnect the power from the router while continuing to hold down the reset button.
3. Reconnect the power after five seconds.
4. Continue to hold the reset button for 30 seconds.

How do I access Buffalo AirStation?

Connect the AirStation to the PC and power both devices on. Launch a web browser and enter the AirStation’s IP address into the address bar. If you do not know the AirStation’s IP address, check the setup card included in your AirStation’s package, or use AirStation Configuration Tool to display it. Log in to Settings.

How do I reset my Buffalo WHR HP G300N?

To reset the Buffalo WHR-HP-G300N to its default settings, you have to do the following steps:

1. Switch on router.
2. Press RESET button and hold for at least 5 seconds.
3. Device restarts automatically.
4. Restoration of standard settings is finished.

How do I setup my Buffalo WIFI router?

Changing the SSID (Network Name) on a Buffalo AirStation

1. Connect the AirStation to the PC and power both devices on.
2. Launch a web browser and enter the AirStation’s IP address into the address bar.
3. Log in to Settings.
4. Click the “Wireless” tile.
5. Enter a new SSID for the 11n and/or the 11ac network, then click Apply.

What is Buffalo Airstation default password?

The default username is “admin” and the default password is “password”. Click the “Wireless” tile. Enter a new SSID for the 11n and/or the 11ac network, then click Apply.

How do I reset my Buffalo router password?

Forgotten password / Reset for Wireless devices

1. Look for the INIT or Reset button on the device. Press and hold for about 10 seconds (The only exception is the WBMR-G54, here press the reset button for about 20 seconds).
2. If the red diag light starts flashing release the button. Wait until the router is restarted. (

What is the IP address for Buffalo AirStation?

192.168.11.1
By default, your AirStation is accessible on your local network at the IP address 192.168. 11.1 with subnet mask 255.255. 255.0.

How do I connect to Buffalo WIFI?

Knowledge Base

1. Connect the AirStation to the PC and power both devices on.
2. Launch a web browser and enter the AirStation’s IP address into the address bar.
3. Log in to Settings.
4. Click the “Wireless” tile.
5. Enter a new SSID for the 11n and/or the 11ac network, then click Apply.

What wireless standards does the whr-g300n support?

WHR-G300N V2 User Manual WHR-G300N User Manual 5 Chapter 1 Product Overview Features Supports IEEE802.11n and IEEE802.11b/g With support for Wireless-N, Wireless-G, and Wireless-B standards, the AirStations can transfer data to and from all standard 2.4 GHz wireless clients.

How do I reset the whr-g300n to the factory defaults?

WHR-G300N User Manual 6 Chapter 1 Product Overview Initialization To restore settings back to the factory defaults, hold down the Reset button on the bottom of the unit. Browser Based Administration These units can be easily configured from a web browser on your computer.

What wireless standards are supported by the airstations?

Supports IEEE802.11n and IEEE802.11b/g With support for Wireless-N, Wireless-G, and Wireless-B standards, the AirStations can transfer data to and from all standard 2.4 GHz wireless clients. Dual speed mode Dual speed mode makes wireless transmission faster by using 2 channels, allowing 300Mbps transmission.