How do you set the time on a Lathem atomic clock?

How do you set the time on a Lathem atomic clock?

To set the time:

1. Remove the top cover.
2. Press and hold the DATE/TIME button for 3 seconds.
3. When the 7500E beeps, release the DATE/TIME.
4. Push the DATE/TIME button and position the Indicator Mark next to the TIME.
5. Press CHANGE to set the Hour.
6. Press SET to save the change.
7. Press CHANGE to set the Minutes.

How do I reset my Lathem clock?

How To Perform A Reset On A 7500E

1. Insert the key into the Top Cover and turn it 1/4 turn to unlock the cover.
2. By holding the left and right sides, lift the Top Cover up.
3. Press and hold the DATE/TIME and CHANGE.
4. Press and release the Reset Switch.
5. When the 7500E display goes blank, release the DATE/TIME and CHANGE.

How do I change the time on my Lathem atomic time 1600E?

What To Do If the Time Jumps One Hour On The 1600E

1. Remove the top cover from the clock.
2. Press the SELECT button and position the. mark at the “TIME ZONE”.
3. Press the CHANGE button to select the correct time zone listed in the image below.
4. After you finish setting the time zone, press the SET button once again.

How do I set the date and time on my Lathem 800p?

To enter the ‘Setup Mode’ for date and other functions, press the – and SET buttons at the same time. forward or the – button to scroll backwards. With the desired month showing on the display, press the SET button. The ‘Set Date’ function (2) will display next.

How do I setup my Lathem 400E?

How To Set The Time On The 400E

1. Place the clock in programming mode by using the included key to remove the top cover and flip the switch on the left to “Programming Mode”(to the right).
2. When P1 is displayed on the screen, press Enter.
3. Press + or – until the number on the lower left shows 7.
4. Press Enter.